Tuesday, June 16, 2015

Hotpads

This is a quick, easy project ideal for gifts or for your own use. These can be used as potholders, hotpads, candle mats--really any situation where you wish to protect a surface from heat.

You will need a protective thermal material (I use Insul-Bright), batting or flannel, and the decorative fabric you want for the outside. You will also need a dinner plate, a pen, scissors, a sewing machine, and an iron.




Cut Your Materials



As I mentioned above, I use Insul-Bright as my thermal layer. I'm sure other brands are available, but I've always had good luck with this one. It has a reflective layer in the middle to prevent heat from coming through the pad.


I am not affliliated with the company that makes this.




You are going to cut five circles for each pad:


One of your thermal material,

Draw around the plate. You can use a smaller plate if you want a smaller hotpad, though it can be more difficult to bind the smaller size.



Cut out with scissors.




Two of cotton batting (or cotton flannel),






And two of your decorative fabric.

These may be the same fabric, or you may choose two different ones.






 Layer Your Hotpad


First, place one of your decorative fabrics on a surface, right side down.







Second, add a layer of batting.






Third is your thermal layer.






Fourth, a second layer of batting.






Finally, add your second layer of decorative fabric, right side up.







You can pin or clip these together as you like.

On the right, you can see that I have already prepared my binding strips.






Quilt


You can quilt these with a straight line grid or with free motion quilting (FMQ). I used FMQ because these small items give me a low-pressure chance to practice the technique.













Here are my quilted pads.












Bind Your Hotpads



I use binding cut at 2.5" wide. I then press it in half, so I have a double layer.

To determine the length you will need, multiply the diameter of your pad by π (3.14):

in my case, 10.5" x π = 32.97",

so one width-of-fabric strip (about 40") will be plenty with a little left over. You may cut bias strips if you wish, but I've done them both ways, and I found no advantage to bias over straight grain strips.




Sew the binding around the hotpad, easing it around the curves. Dont rush; this isn't hard, but it does take time. Join the ends as you would any binding.








Here is one with binding attached:


I promise it won't have a ruffle when you are done!




Trim your seam to reduce bulk.










Now, turn the binding toward the back side,




and stitch it down. You can do this with your sewing machine, or as I do, by hand.


EDITED TO ADD:

Recently, I've been adding hanging loops to these.

 

Easy to do--just use about 5" of your binding to make a double-fold strip and layer it in when you sew on the binding.

 


I made several of these in one day; the project lends itself to an assembly-line process. Here are my results:










Most of these are double-sided. Here they are flipped over:






If you decide to do double-sided ones, be sure to choose a binding color that works with both sides.

You may wish to press these with steam when you are done to ensure they lie completely flat.

3 comments:

I love your comments! I have, however, had to add moderation of comments because of spammers. Thanks for your patience.
Happy Quilting,
The Eclectic Abuela